zclip_front

view_transf.zclip_front(p0: float) → int

Sets the position of the back/front z-clip plane

This value is used only when “view_transf: zclip_float” is OFF. Since transformations can be different per viewport, this can be set for each viewport, thus a viewport selection is needed if more than one viewport is being used.

Args:

p0:

‘z_loc’ z coordinate of the back/front z-clipping plane

Examples:

# 
# Select viewport 
# 
ensight.viewport.select_begin(1)
# 
# Set z-clip float OFF and set the location 
# the front and back clipping planes 
# 
ensight.view_transf.zclip_float("OFF")
ensight.view_transf.zclip_front(7.2296e+00)
ensight.view_transf.zclip_back(3.5459e+01)

Returns:

zero on success, non-zero on error